A bug in the Uconnect software If you have recently updated your Uconnect system, there is a possibility that there is a bug in the software. It’s a good idea to inspect and replace these where necessary. This is usually related to the F49 and F67 fuses. A common report attributed to this is the screen peeling and eventually not working anymore. The causes for this are numerous but one of the most common is people cleaning the UConnect touch screen using corrosive material or water-based products. Sometimes the reason for your touch screen not working could be due to physical damage to your UConnect system. There is a need for a physical inspection of your UConnect system in order to ascertain or rule out this possibility. It’s linked to the above point but loose power and other connector cables could be the cause of your problem. You can attempt to fix this yourself if you are technically inclined or you can have professionals look at it once you have exhausted any DIY remedies. The problem could be hardware-related and be caused by a short circuit. The glitch can manifest in several different ways but will ultimately render the touch screen unusable. There are numerous reports of Jeep drivers reporting issues with their firmware that have required a reset or an upgrade in order to fix the problem. It’s quite common for the firmware in the UConnect to glitch. What are the possible causes of your touch screen not working properly? There are several possible causes of this issue and each individual cause will require a different method for fixing it. It will also load with the SRT logo and take several minutes to hours before it will look the same as it did before.5 Final Thoughts Why is the Uconnect Touch Screen not Working? This will wipe all of your personal settings and take it back to factory default. Uconnect Factory (Engineering) reset: Hold temp up and down buttons to access engineering menu. How do you reset the Uconnect on a 2011 Jeep Grand Cherokee? Confirm the reset by following the prompts. 
Following the next set of prompts, say “Reset.”.Press the Uconnect phone button, located on the steering wheel or the center console.Q: How do I reset the Uconnect phone system? To reset the 2012 jeep grand cherokee radio you will do so by holding down the two dial button which are volum and broswe/enter for ten seconds and this will reset the radio. How do you reset the radio on a 2012 Jeep Grand Cherokee? Turn the ignition key to the ACC or ON position. This is done by pressing the preset radio buttons corresponding to the code numbers. When your radio displays the word “CODE”, you will need to enter this security code from 4 to 5 digits.
How do I get the radio code for my Jeep Cherokee?Īlmost all Jeep radio codes consist of 4 to 5 digits.
0 kommentar(er)
